[et_pb_section fb_built=”1″ _builder_version=”4.4.7″][et_pb_row column_structure=”1_4,1_4,1_4,1_4″ _builder_version=”4.4.7″][et_pb_column type=”1_4″ _builder_version=”4.4.7″][et_pb_image src=”https:\/\/builditfull.com\/site\/wp-content\/uploads\/2020\/05\/Bed_leveling_issue01.jpg” show_in_lightbox=”on” _builder_version=”4.4.7″][\/et_pb_image][\/et_pb_column][et_pb_column type=”1_4″ _builder_version=”4.4.7″][et_pb_image src=”https:\/\/builditfull.com\/site\/wp-content\/uploads\/2020\/05\/Bed_leveling_issue02.jpg” show_in_lightbox=”on” _builder_version=”4.4.7″][\/et_pb_image][\/et_pb_column][et_pb_column type=”1_4″ _builder_version=”4.4.7″][et_pb_image src=”https:\/\/builditfull.com\/site\/wp-content\/uploads\/2020\/06\/warping01.jpg” show_in_lightbox=”on” _builder_version=”4.4.7″][\/et_pb_image][\/et_pb_column][et_pb_column type=”1_4″ _builder_version=”4.4.7″][et_pb_image src=”https:\/\/builditfull.com\/site\/wp-content\/uploads\/2020\/05\/rubbing_alcohol01.jpg” show_in_lightbox=”on” _builder_version=”4.4.7″][\/et_pb_image][\/et_pb_column][\/et_pb_row][et_pb_row _builder_version=”4.4.7″][et_pb_column type=”4_4″ _builder_version=”4.4.7″][et_pb_text _builder_version=”4.4.7″ hover_enabled=”0″]<\/p>\n
Bad first layer and warping issue is the most common issue experienced by many beginners.
It can caused by:<\/p>\n
1) Bed not leveled<\/strong> 2) Greasy bed<\/strong> 3) Build platform temperature low<\/strong> For CR10 Pro or CR10 Max, the newer version may come with the energy saver function, turn it off to make sure the bed is heated during the entire printing process.<\/p>\n 4) Print setting issue
If the first layer not printed consistent, some area thicker or some area thinner. Check bed leveling, make sure the bed is leveled properly.
Check out Bed Leveling Problem<\/a>.<\/span><\/p>\n
If you experiencing the first layer adhesion problem, the part warp during printing process, fall off or stuck to the nozzle. Wipe the bed with rubbing alcohol or isopropyl to clean the oil or grease on the bed. They can be bought from local pharmacies.<\/p>\n
If the part warp during printing process. Check the filament printing guide, make the print setting is using the correct bed temperature to the material. If you set it correctly, but the bed just not heating up, check if the heated bed wire connection. Check the heated bed wire on the main board.<\/p>\n
<\/b>Check print setting, make sure first layer speed is slow and hot enough for the first layer to stick firmly on the bed. Turn off the part fan\/cooling on the first layer, we suggest to start the part fan on 2nd or 3rd layer onwards.<\/p>\n