Two Way Pneumatic Connector – Metal (2 pieces)


2 x Two Way Metal Pneumatic Connector.
Suitable for most 3D printers with bowden setup.


In stock

3D printer with bowden setup need PTFE tube, it will worn out time after time if you print a lot.

You will notice the PTFE tube very often worn out only at the end near the heating block. In stead of replace the entire tube, we can just replacing a short piece of tube that goes into the hotend. These 2 way pneumatic connector help saving the PTFE tube.

2 pieces of the TPFE tube will be needed, shorter piece for the hotend part, the longer goes to the extruder side, connect them with the 2 way pneumatic connector, so you only need to replace the shorter end when it's worn out.

Length guide:
For Ender 3, Ender 5 or CR10S, 10c. Longer side just minus 10cm from the original tube that come with your 3D printer.

Here's a handy tools for you to measure and cut the tube flat.

Additional information

Weight 0.05 kg
Dimensions 12 × 16 × 3 cm