ESun PETG test

ESun PETG test

by | Apr 21, 2015 | FDM 3D print | 0 comments

Test print on the Esun PETG filament with our Mix&Match Ring. As an ABS alternative, PETG is tough and flexible like ABS but more stable, lesser shrinkage and can print sharp edges as PLA but not as brittle, there is no irritating fumes while printing. I print at...
Fixing with 3D print part

Fixing with 3D print part

by | Apr 8, 2015 | FDM 3D print | 0 comments

Fixing discontinue Ikea hanging stand’s plastic parts with 3D print. 2 x M6 nut, model the part in sketchup, use back the original M6 screws. Just take a little bit of your time, it can be used for another few more years, why replace when you can repair...
ESun flexible filament test

ESun flexible filament test

by | Apr 3, 2015 | FDM 3D print | 0 comments

Printed my flying elephant with eSun flexible filament like normal PLA temperature 190-220c. No heating plate required. Shrinkage very obvious, although it’s a flexible filament, if you keep pressing the part it may broken after...
Pawns

Pawns

by | Feb 8, 2015 | FDM 3D print | 0 comments

Pawn piece form my robot chess. Printer in red PLA and white ABS. I’ll prefer PLA with the better print result on most my model and it smell nicer...